電子負載可在輸入時設定為最大電流值來模擬短路狀態。短路可由前面板或遠程控制完成。

　　當電子負載為LOAD ON 時，按SHORT鍵，短路功能被啟用，再按一次取消短路模擬。電子負載短路的實際值取決于短路開啟時使用的模式與檔位。其基本限制為電子負載可供應之最大功率檔位。在定電流模式，等同最大電流。在定電阻模式，同現有電阻檔位之最小電阻。在定電壓模式，同零電壓。在定功率模式，同現有功率檔位之最大功率。開啟短路并不會影響到已編程的設定，且在短路關閉后電子負載輸入會回到前一個已編程的值。

　　請注意開啟短路時可能會造成電子負載加載過大電流而觸發電路保護，進而關閉電子負載。